Huawei netengine80e Configuration Manual page 153

HUAWEI NetEngine80E/40E Router
Configuration Guide - Basic Configurations
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Log in to the router through the AUX port.
Refer to Chapter 2
40EConfiguration Guide - Basic Configuration.
Step 2 Use the XModem protocol to receive the file form the AUX port.
The received file is saved on the cfcard memory of the router and the file name is paf.txt.
<HUAWEI> xmodem get cfcard:/paf.txt
**** WARNING ****
xmodem is a slow transfer protocol limited to the current speed
settings of the auxiliary ports.
During the course of the download no exec input/output will be
available!
Proceed?[Y/N]y
Destination filename [cfcard:/ paf.txt]?
Before press ENTER you must choose 'YES' or 'NO'[Y/N]:y
Download with XMODEM protocol....
Step 3 Specify the file to be sent on the HyperTerminal.
Figure 6-6 Specifying the file to be sent
After the configuration, press Send to send the file.
Issue 02 (2011-09-10)
Run the HyperTerminal on the PC and log in to the router.
Use the xmodem get command to download files on the router, and specify the file path
on the HyperTerminal.
Files that are copied to the PC
The path of the file in the PC
"Logging in to the Devices Through the AUX
---- ******* ----
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Managing File System
Port" in the NE80E/
138