Huawei netengine80e Configuration Manual page 21

HUAWEI NetEngine80E/40E Router
Configuration Guide - Basic Configurations
by a PAF file and users do not need to configure it manually. This function is automatically
disabled after the router correctly obtains an IP address. The process of logging in to the
router supporting the plug-and-play function is as follows:
Procedure
Step 1 After planning the network, network planning engineers provide a planning list for software
commissioning engineers.
Step 2 Based on the planning list, software commissioning engineers configure the mappings between
the router locations and IP addresses on the DHCP server, compile configuration scripts, and
configure the mappings between the router locations and scripts.
Step 3 Hardware installation personnel installs the router and power them on at the site.
Step 4 The router sends a DHCPREQUEST message to the DHCP server, and then the interface
connecting to the DHCP server obtains an IP address.
Step 5 The NMS delivers configurations to the router.
----End
Follow-up Procedure
If there is no DHCP server on the network or the router cannot obtain an IP address for some
reason, the router displays the following information:
PNP State!!!PLEASE UNDO PNP enable for manual Setup!
You can undo PNP in system view with "undo pnp enable"
At this time, do as follows to disable the plug-and-play function:
1.
2.
3.
Issue 02 (2011-09-10)
Run the system-view command to enter the system view.
Run the undo pnp enable
Run the undo pnp default route
plug-and-play function.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Logging In to the System for the First Time
command to disable the plug-and-play function.
command to delete the default route generated by the
6