Checking The Configuration; Powering Off The Sfu - Huawei netengine80e Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - Basic Configurations
----End

10.2.3 Checking the Configuration

After the MPU is powered off, you can run the display device command to check whether the
MPU has been powered off.
Context
Run the following commands to check the previous configuration.
Procedure
l
----End
Example
After the power-off operation, run the
the abnormal state, it means that the operation succeeds. For example:
<HUAWEI> display device
NE80E's Device status:
Slot #
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -- - -
5
6
9
12
11
16
17
18
19
20
21
22
23
24
25
26
27
28

10.3 Powering off the SFU

When the SFU is faulty or you need to routinely maintain the SFU, you can power off the SFU.
Issue 02 (2011-09-10)
NOTE
If there is no terminal on the deployment site, you can power off the slave MPU by using the OFL (offline)
button. The OFL button is in the upper part of the slave MPU. Press the button for six seconds.
If the OFL indicator is on, it means that the slave MPU is powered off successfully.
Run:
display device
Check the registration of the SRU/MPU.
Type Online
LPU Present
LPU Present
LPU Present
LPU Present
LPU Present
LPU Present
MPU Present
MPU Present
SFU Present
SFU Present
SFU Present
SFU Present
CLK Present
CLK Present
PWR Present
PWR Present
FAN Present
FAN Present
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
display device command. If the slave SRU/MPU is in
Register Status
Registered Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
Unregistered Abnormal
NA Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
10 Device Maintenance
Primary
NA
NA
NA
NA
NA
NA
Slave
Master
NA
NA
NA
NA
NA
NA
NA
NA
NA
NA
258