Huawei netengine80e Configuration Manual page 60

HUAWEI NetEngine80E/40E Router
Configuration Guide - Basic Configurations
Context
Physical attributes of the AUX user interface have default values on the router and no additional
configuration is needed.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
user-interface
The AUX user interface view is displayed.
Step 3 Run:
speed
The transmission rate is set.
By default, the baud rate is 9600 bit/s.
Step 4 Run:
flow-control
The flow control mode is set.
By default, the flow-control mode is none.
Step 5 Run:
parity
The parity mode is set.
By default, the value is none.
Step 6 Run:
stopbits
The stop bit is set.
By default, the value is 1 bit.
Step 7 Run:
databits
The data bit is set.
By default, the value is 8.
----End
Issue 02 (2011-09-10)
aux interface-number
speed-value
{ hardware | none | software }
{ even | mark | none | odd | space }
{ 1.5 | 1 | 2 }
{ 5 | 6 | 7 | 8 }
NOTE
When the user logs in to a router through an AUX port, the configured attributes for the console port on
the HyperTerminal should be in accordance with the attributes of the AUX user interface on the router.
Otherwise, the user cannot log in to the router.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuring User Interface
45