HUAWEI NetEngine80E/40E Router
Configuration Guide - Basic Configurations
Context
The master device has logged in to the slave device through Telnet. The NAP function is no
longer required, and to ensure security of the network, NAP should be globally disabled on the
slave interface of the slave device.
Do as follows on the router that is configured as the NAP slave device.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
undo nap slave enable
NAP is disabled on the slave device.
----End
10.13.5 Checking the Configuration
After configuring NAP-based remote deployment, you can view the NAP status globally or on
a specified interface.
Prerequisite
NAP-based remote deployment has been completed.
Procedure
Step 1 Using the
Step 2 Using the
the NAP status of the specified interface.
----End
Example
Run the
<HUAWEI> display nap status
Slave port status
Nap ip-pool/Mask
Run the
of the specified interface.
<HUAWEI> display nap interface gigabitethernet1/0/1
l
Issue 02 (2011-09-10)
display nap
status command, you can view the current NAP status.
display nap
interface [ interface-type interface-number ] command, you can view
display nap
status command to view the current NAP status.
display nap
interface interface-type interface-number command to view the NAP status
If the interface is not assigned an IP address, the following information is displayed.
------------------------------------------------------
NAP master port list:
Port count
------------------------------------------------------
Port property
Current status
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: Enable
: 12.12.12.0/24
: 2
: Master
: DETECTING
10 Device Maintenance
286