Checking The Configuration; Powering Off The Npu - Huawei netengine80e Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - Basic Configurations
----End

10.3.3 Checking the Configuration

After the SFU is powered off, you can run the display device command to check whether the
SFU has been powered off.
Context
Run the following commands to check the previous configuration.
Procedure
Step 1 Run:
display device
Check the registration of the SFU.
----End
Example
After the power-off operation, run the
state, it means that the operation succeeds. For example:
<HUAWEI> display device
NE80E's Device status:
Slot #
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -- - -
5
6
9
12
11
16
17
18
19
20
21
22
23
24
25
26
27
28

10.4 Powering off the NPU

This section describes how to power off the NPU.
Issue 02 (2011-09-10)
NOTE
SFU is not supported on the X1 and X2 models of the NE80E/40E.
If there is no terminal on the deployment site, you can power off the slave SFU by using the OFL button.
The OFL button is in the upper part of the slave SFU. Press the button for six seconds. If the OFL indicator
is on, it means that powering off the SFU succeeds.
Type Online
LPU Present
LPU Present
LPU Present
LPU Present
LPU Present
LPU Present
MPU Present
MPU Present
SFU Present
SFU Present
SFU Present
SFU Present
CLK Present
CLK Present
PWR Present
PWR Present
FAN Present
FAN Present
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
display device command. If the SFU is in the unregistered
Register Status
Registered Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
NA Normal
Unregistered Abnormal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
Registered Normal
10 Device Maintenance
Primary
NA
NA
NA
NA
NA
NA
Slave
Master
NA
NA
NA
NA
NA
NA
NA
NA
NA
NA
260