Configuring A Working Mode For An Lpuf-40 Or Lpuf-20/21; Establishing The Configuration Task - Huawei netengine80e Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - Basic Configurations
Procedure
Step 1 Run the
----End
Example
# View the current operation mode of the board in slot 1.
<HUAWEI> display work-mode slot 1
NE40E-4's current work-mode on lpuf-10:
Slot
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
1
10.8 Configuring a Working Mode for an LPUF-40 or
LPUF-20/21
LPUF-20/21 or LPUF-40 support various service modes, which can be configured using
commands.

10.8.1 Establishing the Configuration Task

Before configuring a service mode for an LPU, familiarize yourself with the applicable
environment, complete the pre-configuration tasks, and obtain the data required for the
configuration. This will help you complete the configuration task quickly and accurately.
Applicable Environment
An LPUF-20/21 or LPUF-40 cannot be configured with the 1588v2 ACR server function and
NetStream at the same time. Before configuring either the 1588v2 ACR server function or
NetStream, configure a corresponding service mode for the LPU.
l
l
The LAN_WAN_10G_TM_CARD, ETH_10XGF_TM_CARD, or ETH_6XGF_TM_CARD
subcard can be configured with a service mode to support specified functions. The service modes
and supported service types are as follows:
l
l
Pre-configuration Tasks
Before configuring a service mode for an LPU, complete the following task:
Issue 02 (2011-09-10)
display work-mode
Type Current-workmode
LPUF-10 SUPPORT-ATM
NOTE
LPUs are not supported on NE80E/40E-X1s and NE80E/40E-X2s.
netstream-1-mode: When working in this mode, the LPU can be configured with
NetStream, but not the 1588v2 ACR server function.
ptp-1-mode: When working in this mode, the LPU can be configured with the 1588v2
ACR server function, but not NetStream.
reassemble-mode: When working in this mode, the subcard supports packet fragmentation
and reassembly, but not 1588v2 or the 1588v2 ACR client function.
ptp-slave-mode: When working in this mode, the subcard supports 1588v2 and the 1588v2
ACR client function, but not packet reassembly.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
[slot slot-id] command to view the operation mode of the board.
10 Device Maintenance
268