Configuration Examples; Example For Performing File Operations By Means Of The File System - Huawei netengine80e Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - Basic Configurations
Procedure
l
----End

6.6 Configuration Examples

This section provides an example for performing files by accessing the system and using FTP
or SFTP.These configuration examples explain networking requirements, configuration
roadmap, and configuration notes.
6.6.1 Example for Performing File Operations by Means of the File
System
This section describes how to perform file operations by means of the file system. In this
example, you can log in to the router to view and copy directories.
Networking Requirements
You can log in to the router through the Console interface, AUX interface, Telnet, or STelnet
to perform file operations on the router.
The file path in the storage device must be correct. If the user does not specify a target file name,
the source file name is the name of the target file by default.
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
Issue 02 (2011-09-10)
Run:
xmodem get { filename | devicename }
XModem is used to get the file.
NOTE
l Before getting the file, confirm the path and the name of the file that are to be sent.
l For the filename, an absolute path name is required.
l If the filename is similar to an existing one, the system sends a prompt asking you whether to
overwrite the file or not.
Check the files under a certain directory.
Copy a file to this directory.
Check this directory and view that the file is copied successfully to the specified directory.
Source file name and target file name
Source file path and target file path
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Managing File System
131