Configuring A Cleaning Cycle For The Air Filter; Establishing The Configuration Task - Huawei netengine80e Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - Basic Configurations
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
cmu-switch
temperature } alarm-mode { 0 | 1 }
Monitor items such as objects to be monitored and an alarm mode are configured for a CMU.
----End

10.10 Configuring a Cleaning Cycle for the Air Filter

This section describes the procedure for configuring a cleaning cycle for the air filter.
Context

10.10.1 Establishing the Configuration Task

Application Environment
You need to clean the air filter after the air filter has been running for a period of time.
Pre-configuration Tasks
None.
Data Preparation
To configure a cleaning cycle for the air filter, you need the following data.
No.
1
10.10.2 Configuring a Cleaning Cycle for the Air Filter
Issue 02 (2011-09-10)
switch-id slot slot-id name { voltage | door | humidity | fog |
NOTE
A router can monitor four types of environment variables at a time. You need to run the
command to configure each environment variable that needs to be monitored and the associated alarm
mode.
NOTE
The X1 and X2 models of the NE80E/40E do not have air filter.
Data
Cleaning cycle of the air filter
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Device Maintenance
cmu-switch
272