HUAWEI NetEngine80E/40E Router
Configuration Guide - Basic Configurations
Do as follows on the router that serves as the TFTP client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
acl
The ACL view is displayed.
Step 3 Run:
rule
source-wildcard | any } | time-range time-name | vpn-instance vpn-instance-name ]
The ACL rule is configured.
Step 4 Run:
quit
The system view is displayed.
Step 5 Run:
tftp-server acl
The ACL can be used to limit the access to the TFTP server.
----End
8.5.4 Downloading Files by Using TFTP
You can download files from the TFTP server to the TFTP client.
Do as follows on the router that serves as the TFTP client:
Procedure
l
----End
8.5.5 Uploading Files by Using TFTP
You can upload files from the TFTP client to the TFTP server.
Do as follows on the router that serves as the TFTP client:
Issue 02 (2011-09-10)
acl-number
[ rule-id ] { deny | permit } [ fragment | logging | source { source-ip-address
acl-number
Run the following commands according to the type of the server IP addresses.
– The IP address of the server is IPv4 address, run:
tftp
[ -a source-ip-address | -i interface-type interface-number ] tftp-
server [ public-net | vpn-instance vpn-instance-name ] get source-filename
[ destination-filename ]
The router is configured to download files through TFTP.
– The IP address of the server is IPv6 address, run:
tftp ipv6
[ -a source-ip-address ] tftp-server-ipv6 [ -i interface-type
interface-number ] get source-filename [ destination-filename ]
The router is configured to download files through TFTP.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Accessing Another Device
*
169