Resetting The Configuration To The Default Settings - Hirschmann RS20 User Manual

Loading/saving settings
Note: The loading process started by DHCP/BOOTP
"System configuration via BOOTP")
locally" in the "Load" frame. If you get an error message when saving a
configuration, this could be due to an active loading process. DHCP/BOOTP
only finishes a loading process when a valid configuration has been loaded.
If DHCP/BOOTP does not find a valid configuration, then finish the loading
process by loading the local configuration in the "Load" frame.
3.1.3 Resetting the configuration to the default
settings
The device enables you to
 reset the current configuration to the default setting. The locally saved
configuration is kept.
 reset the device to the default setting. After the next restart, the IP
address is also in the default setting.
 Select the
Basics: Load/Save dialog.
 Make your selection in the "Delete" frame.
 Click "Delete configuration". The device will delete its configuration
immediately.
Resetting the device using the system monitor
 Select 5 "Erase main configuration file"
This menu item allows you to reset the current configuration, stored in non
volatile memory, to its default setting. The device also stores a backup
configuration, and a configuration associated with the firmware, in its
Flash memory.
 Press the Enter key to delete the configuration file.
58
shows the selection of "from URL & save
3.1 Loading settings
(see on page 39
UM BasicConfig L2E
Release 8.0 05/2013