Hirschmann RS20 User Manual page 49

Entering the IP Parameters
Figure 13: Network parameters dialog
 Under "Mode", you enter where the device gets its IP parameters:
 In the BOOTP mode, the configuration is via a BOOTP or DHCP
server on the basis of the MAC address of the device.
See "Setting up a DHCP/BOOTP Server" on page 190.
 In the DHCP mode, the configuration is via a DHCP server on the
basis of the MAC address or the name of the device.
See "Setting up a DHCP Server with Option 82" on page 196.
 In the "local" mode the net parameters in the device memory are used.
 Enter the parameters on the right according to the selected mode.
 You enter the name applicable to the DHCP protocol in the "Name" line in
the
Basic Settings:System
UM BasicConfig L2E
Release 8.0 05/2013
2.8 Graphical User Interface IP Confi-
dialog of the graphical user interface.
guration
49