Hirschmann RS20 User Manual page 88

Assistance in the Protection from
Unauthorized Access
 Select the Security:SNMPv1/v2 access dialog.
With this dialog you can select the access via SNMPv1 or SNMPv2.
In the state on delivery, both protocols are activated. You can thus
manage the device with HiVision and communicate with earlier
versions of SNMP.
If you select SNMPv1 or SNMPv2, you can specify in the table via which
IP addresses the device may be accessed, and what kinds of
passwords are to be used.
Up to 8 entries can be made in the table.
For security reasons, the read password and the read/write password
must not be identical.
Please note that passwords are case-sensitive.
Index
Password
IP Address
IP Mask
Access
Mode
Active
88
Serial number for this table entry
Password with which this computer can access the
device. This password is independent of the SNMPv2
password.
IP address of the computer that can access the device.
IP mask for the IP address
The access mode determines whether the computer has
read-only or read-write access.
Enable/disable this table entry.
6.2 Password for SNMP access
UM BasicConfig L2E
Release 8.0 05/2013