Hirschmann RS20 User Manual page 155

Network Load Control
 Open the
Figure 39: Assigning and saving "Port VLAN ID", "Acceptable Frame Types"
and "Ingress Filtering"
 Assign the ID of the related VLANs (1 to 3) to the individual ports.
 Because terminal devices usually send data packets as untagged,
you select the admitAll setting for the terminal device ports.
Configure the uplink port with admit only VLAN tags.
 To evaluate the VLAN tag on this port, activate "Ingress Filtering" on
the uplink port.
 Click "Set" to save the changes temporarily.
 Select the
Basics: Load/Save dialog.
 In the "Save" frame, select "To Device" for the location and click
"Save" to permanently save the configuration in the active
configuration.
enable
configure
interface 1/1
vlan participation include 1 Port 1/1 becomes member untagged in VLAN 1.
vlan participation include 2 Port 1/1 becomes member untagged in VLAN 2.
vlan tagging 2
UM BasicConfig L2E
Release 8.0 05/2013
Switching:VLAN:Port
dialog.
Switch to the privileged EXEC mode.
Switch to the Configuration mode.
Switch to the Interface Configuration mode of
interface 1/1.
Port 1/1 becomes member tagged in VLAN 2.
8.6 VLANs
155