Making Basic Settings; First Login (Password Change) - Hirschmann EAGLE20 User Manual

3

Making basic settings

Note: 2 or more devices configured with the same IP address can cause
unpredictable operation of your network.
Install and maintain a process that assigns a unique IP address to every
device in the network.
The IP parameters must be entered when the device is installed for the first
time. The device provides the following options for configuring IP addresses:

Input via the V.24 interface
 Input via the HiView or Industrial HiVision application. You find further
information about the applications HiView or Industrial HiVision on the
Internet at the Hirschmann product pages:
HiView
http://www.hirschmann.com/en/QR/INET-HiView
Industrial HiVision
http://www.hirschmann.com/en/QR/INET-Industrial-HiVision
 AutoConfiguration Adapter
Default settings


V.24 data rate: 9600 Baud
 Ethernet ports: link status is not evaluated (signal contact)

Optical ports: Full duplex
TP ports: Autonegotiation
3.1

First login (Password change)

To help prevent undesired access to the device, it is imperative that you
change the default password during initial setup.
Perform the following steps:
 Open the Graphical User Interface, the Command Line Interface, or
HiView the first time you log on to the device.
 Log on to the device with the default password "". The device prompts you
to type in a new password.
 Type in your new password.
To help increase security, choose a password that contains at least 8
characters which includes upper-case characters, lower-case characters,
numerical digits, and special characters.
 When you log on to the device with the Command Line Interface, then the
device prompts you to confirm your new password.
 Log on to the device again with your new password.
Installation EAGLE20/30
Release 12 03/2021
41