Entering The Ip Parameters Via Hidiscovery - Hirschmann RS20 User Manual

Entering the IP Parameters
2.3 Entering the IP Parameters
via HiDiscovery
The HiDiscovery protocol enables you to assign IP parameters to the device
via the Ethernet.
You can easily configure other parameters via the graphical user interface
(see the "GUI" Graphic User Interface reference manual).
Install the HiDiscovery software on your PC. The software is on the CD
supplied with the device.
 To install it, you start the installation program on the CD.
 Start the HiDiscovery program.
When you start HiDiscovery, it automatically searches the network for those
devices which support the HiDiscovery protocol.
HiDiscovery uses the first network interface found for the PC. If your
computer has several network cards, you select the one you desire in the
HiDiscovery toolbar.
HiDiscovery displays a line for every device that reacts to the HiDiscovery
protocol.
HiDiscovery enables you to identify the devices displayed.
 Select a device line.
 Click the „Signal" symbol on the tool bar to set the LEDs for the selected
device to flashing on. To switch off the flashing, click on the symbol again.
 By double-clicking a line, you open a window in which you enter the
device name and the IP parameters.
Note: When the IP address is entered, the device copies the local
configuration settings
UM BasicConfig L2E
Release 8.0 05/2013
(see on page 53 "Loading/saving
2.3 Entering the IP Parameters via
settings").
HiDiscovery
35