Global Settings - Hirschmann RS20 User Manual

Configuring the Ports
Nominal power for OCTOPUS 8M-PoE:
The device provides the nominal power for the sum of all PoE ports, plus
a power reserve. Since the device draws its PoE voltage from outside, it
cannot know what the nominal power is.
Instead, the device therefore assumes a nominal power value of 15 Watt
per PoE port.
 Global settings
– For devices with PoE select the
Basic Settings:Power over Ethernet dialog.
– For devices with PoE select the
Basic Settings:Power over Ethernet Plus:Global dialog.
Frame "Operation":
 With "Function On/Off" you turn the PoE on or off.
Frame "Configuration":
 With "Send Trap" you can get the device to send a trap in the
following cases:
– If a value exceeds/falls below the performance threshold.
– If the PoE supply voltage is switched on/off on at least one port.
 Enter the power threshold in "Threshold". When the device exceeds
or is below this value, the device will send a trap, provided that you
enable the "Send Trap" function. For the power threshold you enter
the power yielded as a percentage of the nominal power.
 "Budget [W]" displays the power that the device nominally provides
to the PoE ports.
 "Reserved [W]" displays the maximum power that the device
provides to the connected PoE devices on the basis of their
classification.
 "Delivered [W]" shows how large the current power requirement is
on the PoE ports.
The difference between the "nominal" and "reserved" power indicates
how much power is still available to the free PoE+ ports.
UM BasicConfig L2E
Release 8.0 05/2013
79