Hirschmann RS20 User Manual page 138

Network Load Control
enable
network priority dot1p-vlan
7
exit
show network
System IP Address.............................. 10.0.1.116
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.0.1.200
Burned In MAC Address.......................... 00:80:63:51:7A:80
Network Configuration Protocol (BootP/DHCP).... None
DHCP Client ID (same as SNMP System Name)...... "PowerMICE-517A80"
Network Configuration Protocol HiDiscovery..... Read-Write
Management VLAN ID............................. 1
Management VLAN Priority....................... 7
Management IP-DSCP Value....................... 0(be/cs0)
Web Mode....................................... Enable
JavaScript Mode................................ Enable
Configuring Layer 3 management priority

 Open the
 In the "IP DSCP Value for Management packets" field, you enter the
IP DSCP value with which the device sends management packets.
enable
network priority ip-dscp
cs7
exit
show network
138
QoS/Priority:Global
Switch to the privileged EXEC mode.
Assign the value 7 to the management priority so
that management packets with the highest priority
are sent.
Switch to the privileged EXEC mode.
Displays the management VLAN priority.
dialog.
Switch to the privileged EXEC mode.
Assign the value cs7 to the management priority so
that management packets with the highest priority
are handled.
Switch to the privileged EXEC mode.
Displays the management VLAN priority.
8.4 QoS/Priority
UM BasicConfig L2E
Release 8.0 05/2013