Entering The Ip Parameters Via Hidiscovery - Hirschmann Power MICE User Manual

Entering the IP parameters
2.3 Entering the IP parameters
via HiDiscovery
The HiDiscovery protocol enables you to assign IP parameters to the Switch
via the Ethernet.
You can easily configure additional parameters with the Web-based mana-
gement (see Reference manual „Web-based Interface").
Install the HiDiscovery software on your PC. The software is on the CD sup-
plied with the Switch.
V To install it, you start the installation program on the CD.
Note: The installation of HiDiscovery involves installing the WinPcap Version
3.0 software package.
If an earlier version of WinPcap is already installed on the PC, then you must
first uninstall it. A newer version remains intact when you install HiDiscovery.
However, this can not be guaranteed for all future versions of WinPcap. In
the event that the installation of HiDiscovery has overwritten a newer version
of WinPcap, then you uninstall WinPcap 3.0 and then re-install the new ver-
sion.
V Start the HiDiscovery program.
Fig. 10: HiDiscovery
Basic - L3P
Release 3.1 06/07

2.3 Entering the IP parameters via HiDiscovery

35