Table of Contents
Advertisement
Spectrometer Installation
Electrical connections
Warning: Electrical Hazard
To prevent potential injury to yourself and damage to the instrument, switch
Read the following instructions very carefully before connecting any cables.
See Chapter 6, Laboratory Requirements for the specification of the line power
supply.
Summary
1. Make sure that the spectrometer and the cooling system (where applicable)
are switched off.
2. Switch the circuit breaker on the rear panel of the spectrometer to the off
position (marked ).
3. Switch off the computer and all other instruments that you will connect to the
spectrometer or computer. See the guides for the individual instruments for
the procedure to use.
4. Disconnect the line power cords of the spectrometer and all other instruments
from the line power supply.
5. Connect the instrument control cables and power cords as shown on the
following page.
6. When you have completed all connections, switch on the system (see
'Switching on the system', page 3-3).
2-22
OFF all instruments in the system and disconnect them from the line power
supply before you perform the procedures described below.
W2.3
0993-5255
Hide quick links:
Advertisement
Table of Contents
