Moving And Reinstalling The Spectrometer; Preparing The Spectrometer To Be Moved - PerkinElmer AAnalyst 700 User Manual

Spectrometer Installation

Moving and reinstalling the spectrometer

We recommend that only a PerkinElmer service engineer or a PerkinElmer
trained and authorized person moves and reinstalls the spectrometer.
Should you attempt to do this yourself, PerkinElmer cannot be held responsible
for any damage or malfunctioning of the spectrometer.
The instructions here are primarily intended for occasions where you may want
to move the spectrometer short distances to a new location within the laboratory.
Read the instructions carefully and be sure you understand them thoroughly
before you attempt to move the spectrometer. Read the detailed information given
in the relevant sections of this chapter before you reinstall the spectrometer.
If you intend to transport the spectrometer over a longer distance, contact your
local PerkinElmer office since internal shipping locks must be set via the service
software, inside the spectrometer.

Preparing the spectrometer to be moved

1. Close the AA WinLab application, then shut down the Windows operating
system.
2. Switch off the spectrometer, computer and all the accessories.
3. Disconnect all the electrical cables.
4. Remove the furnace autosampler from the spectrometer (see 'Removing the
autosampler from the spectrometer' in the Graphite Furnace User's Guide).
5. Disconnect the burner gas supplies.
6. Disconnect the drain system from the burner.
7. Disconnect the furnace gas supplies.
8. Disconnect the cooling water supply.
9. Prepare the computer and other system components for transport as described
in their own guides.
10. Attach the original handles securely. Only use the original handles and
screws.
Note: Make sure that the handles are properly secure before you move the
spectrometer.
2-4
0993-5255