Repairing The Differential; Disassembling The Differential Unit - Iveco daily euro 4 Repair Manual

22
REAR AXLE NDA RS
Figure 19
NOTE The brake lining with the wear indicator must be
mounted on the piston side of the brake caliper.
Rest the brake caliper (2) with the brake linings on the
mounting.
NOTE Should brake calliper piston be moved backward,
use tool 99372236
recommendations set out in the BRAKES section.
Tighten the screws (1) securing the caliper (2) to the
required torque.
After assembly, fill the axle housing with TUTELA W90/M -
DA oil in the required quantity and grade.
526210

REPAIRING THE DIFFERENTIAL

Disassembling the differential unit

NOTE Before repairing the differential it is necessary to
drain off the oil and dismantle the drive shafts, as
described under the heading of overhauling the
wheel hub (operation 525030).
Figure 20
Unscrew screws (1) complete with safety washers and take
off wheelwork inspection cover (2).
Base - March 2006
107985
and follow the
NOTE
107838
Figure 21
Mark the position of the caps (1 and 2), take out the screws
(3) and remove them.
Figure 22
Take differential box (1), comprehensive of ring gear,
wheelwork, bearings (2-5), adjusting shims (4) and rib rings
(3), out of rear axle box.
Write down the positions of adjusting shims, rib
rings and bearing outer rings in order to be able to
arrange them according to original configuration
on mounting step.
D E 4
AILY URO
108043
108044
Print 603.93.651