Table of Contents
Advertisement
28
5 S 300 TRANSMISSIONS
530210
OVERHAULING THE TRANSMISSION
Figure 14
Remove the plug and drain off the lubricating oil.
The used oil must be disposed of according to the law
in force.
Fit the gearbox (1) with the bracket 99371057 (4) and secure
this to the brackets 99322225 (3) on the rotary stand
99322205 (2).
530220
Gear control box
Disassembly
Figure 15
Take tie-rod (3) off by disconnecting jointed heads (1) from
levers (4 and 7).
Take tie-rod (8) off by disconnecting jointed heads (9) from
levers (10 and 2).
NOTE
Tie-rods (3 and 8) are interchangeable.
Remove screws (5), then take transfer case (6) off the gearbox
unit.
Base - March 2006
Figure 16
108638
Take out the fixing screws (1) and remove the gear control box
(2).
Figure 17
Loosen the nuts (3) for the retaining screws (6).
Extract the levers (2 and 7) from the shafts (1 and 8) and
extract these from the box (5). Take off the caps (4).
Figure 18
108857
With a punch (3), remove the spring pin (4) and extract the
shaft (2) from the internal lever (1).
Repeat these steps for the other shaft.
D
E
4
AILY
URO
51383
51384
51385
Print 603.93.651
Advertisement
Table of Contents
