Table of Contents
Advertisement
D
E
AILY
URO 4
PRINT 603.43.351
500760
OVERHAULING THE SUSPENSION
TIE RODS
Removal
Figure 32
Remove the stabilizer bar as described under the relevant
heading (operation 528030).
Take out the nut for the screw (2) securing the tie rod (3)
to the bottom suspension arm (1) and remove the screw (2)
from this.
Take out the nut securing the link pin (5) to the mounting (4).
Using the extractor 99347060, remove the swivel head (5)
from the mounting (4).
Figure 33
Using the extractor 99347060 (1), detach the stub axle (2)
from the mounting (4) Figure 22.
Remove the screw stay (3) from the vehicle.
Print 603.93.651
Figure 34
Take out the nut (3) for the screw (4) securing the tie rod
(1) to the top suspension arm (2) and remove the screw (4)
from this. Take out the nut securing the link pin (5) to the
mounting (7). Using the extractor 99347074 (6), remove the
44664
swivel head (5) from the mounting (7). Remove the screw
stay (1) from the vehicle.
NOTE
If removing the mounting (7), so as not to change the
wheel geometry, not the number and thickness of
the spacers (if there are any) under the mounting to
mount them in the same way when refitting the
mounting (7).
500764
Replacing swivel heads
Figure 35
1
2
3
Loosen the nut (2) and unscrew the swivel head (1) from the
top tie rod (3).
Screw the new swivel head (1) onto the tie rod (3)
positioning it at the values shown in the figure.
Figure 36
1
2
3
Loosen the nut (2) and unscrew the swivel head (1) from the
75359
bottom tie rod (3).
Screw the new swivel head (1) onto the tie rod (3)
positioning it at the values shown in the figure.
Tighten the nut (2) to the prescribed torque.
FRONT MECHANICAL SUSPENSIONS
378 ± 0.8
364.5 ± 0.7
Base - March 2006
33
75360
44666
19056
Advertisement
Table of Contents
