Table of Contents
Advertisement
D
E
4
AILY
URO
Figure 277
Lubricate the seal ring of the oil filter (2) with engine oil and
fasten it on the heat exchanger (3). Use tool 99360076 (1)
to tighten the oil filter to the prescribed torque.
Figure 278
If present, fit the support (3), drive in the screws (4) and
tighten them to the prescribed torque.
Fit the fixed backstand (2), drive in the screw (1) and tighten
it to the prescribed torque.
Figure 279
Fit the air-conditioner compressor (if any) into place, then
tighten the fastening screws to the specified torque and fit
elastic belt (4) into place, as described below.
Print 603.93.651
NOTE
To fit the air-conditioner compressor elastic drive
belt into place, tool 99360191 (2) must be used.
Any other tool or method may cause dangerous
tension to the elastic belt.
Fit the flexible belt (3) equipped with tool 99360191 (2) on
the pulley (4) and apply the tool on the pulley (1).
Turn the drive shaft counterclockwise (⇒) until the belt fits
perfectly on the pulley (1).
107709
NOTE
The elastic belt shall be replaced with a new one
every time it is disassembled.
Figure 280
88252
Fit the pipe (4) of the oil level dip rod and fasten the support
bracket on the cylinder head by tightening the screw (3) to
the prescribed torque.
Fit cooling fan (1), if any, back to electromagnetic joint (2).
90650
269
F1C ENGINE
107750
Base - March 2006
Advertisement
Table of Contents
