Overhauling Engine F1C; Disassembling The Engine At The Bench - Iveco daily euro 4 Repair Manual

D E 4
AILY URO
Print 603.43.671/A

OVERHAULING ENGINE F1C

540110 DISASSEMBLING THE ENGINE
AT THE BENCH
Figure 59
To fit the engine base with the brackets securing the rotor
to the overhaul bench, disassemble the left and right engine
mounts (3), then disconnect oil pipe (2) from turboblower
(1) and engine base connection (4).
NOTE Block the turbocharger air/exhaust gas inlets and
outlets to prevent foreign bodies getting inside.
Figure 60
Print 603.93.651
Fit the brackets 99361041 (11) to the crankcase and use
these to secure the engine to the rotary stand 99322205
(12). Drain the oil from the engine by removing the plug from
the oil sump.
If fitted, remove the fan (1) from the electro-magnetic joint
(2).
Remove the items below, if they have not yet been removed
prior to detachment:
- upper sound-proofing cover;
- engine cable complete with raceway (6), by
disconnecting the electric connections of the same
from:
- electric injectors (1);
- preheating plugs (3);
- hydraulic accumulator pressure sensor (5);
- throttle valve actuator (7);
- inlet manifold air pressure/temperature sensor (8);
107701
- revs sensor (4);
- high-pressure pump pressure regulator (10);
- phase sensor (2);
- thermostat coolant temperature sensor (9).
221
F1C ENGINE
107702
Base - March 2006