Table of Contents
Advertisement
D
E
4
AILY
URO
Figure 65
Fit the seal ring (2) in the axle casing with tool 99374201 (1).
Figure 66
Fit the transmission connecting flange (1) and the bevel pinion
retaining nut (2).
Figure 67
Assemble the flange (3) and prevent rotation with tool
99370317 (1).
Using the torque wrench (2), tighten the bevel pinion flange
(3) retaining nut to the correct torque value.
Print 603.93.651
Figure 68
Using the torque wrench 99389819 (1), measure the rolling
74730
torque of the bevel pinion.
NOTE
The rolling torque must be measured at an ambient
temperature of 25°C, making the pinion turn at a
speed of 50 rpm after it has made 10 turns.
If the value is incorrect disassemble the pinion (2, Figure 64),
and replace the adjuster ring (3, Figure 63) with a suitable ring.
Refit the pinion and repeat the rolling torque check.
33113
Differential unit refitting
Figure 69
74731
Fit gearing case supporting bearing outer rings (2) and then
position the gearing case (1), previously fitted, in the rear axle
casing.
109
REAR AXLE 450517/2
32480
33116
Base - March 2006
Advertisement
Table of Contents
