Cynder Head Refitting - Iveco daily euro 4 Repair Manual

258
F1C ENGINE
Figure 220
Position the chain (1) on the gears (2, 3 and 5) and fit the gear
(3) on the stem (4) so that the chain (1) in tracts A and B is
tensioned.
Figure 221
Fit the stem with the drive gear (2) on the high pressure
pump control stem (1).
Drive in the fastening screw (3).
Figure 222
Check the conditions of the fixed skids (1 and 3) and change
them if worn out.
Fit the skid (1) and drive in the fastening screws (2), then
tighten them to the prescribed torque.
Fit the skid (3) and drive in the fastening screws (4), then
tighten them to the prescribed torque.
Base - March 2006

Cynder head refitting

Figure 223
88351
Check that the mating surfaces of the cylinder head and
crankcase are clean.
Keep the cylinder head gasket clean.
Place the gasket (1) of the cylinder head with the thickness
given in section "Check piston protrusion", with the "TOP"
sign facing the head.
NOTE It is essential to keep the gasket sealed in its package
until just before assembly.
Figure 224
88274
α
Mount the cylinder head (2).
Screw down the fixing screws (3) and tighten them, in three
successive stages, following the order and methods shown in
the following figure.
88352
NOTE The angle closure is done with tool 99395216 (1).
D E 4
AILY URO
88353
88354
Print 603.93.651