Calibration In Case Of Replacement Of The Clutch Actuator; Calibration In Case Of Replacement Of The Gearbox Actuator Or An Electric Motor Of The Gearbox Actuator; Calibration In Case Of Replacement Of The Clutch Engaging/Release Fork - Iveco daily euro 4 Repair Manual

D E 4
AILY URO
NOTE Wait 10 seconds prior to the next KEY ON.
When the procedure has been completed, check the control unit memory and verify that no error is found.

Calibration in case of replacement of the clutch actuator

Clear the control unit error memory.
Get connected to the vehicle by means of the diagnosis instrument, with the vehicle stationary, engine OFF and gearshift lever
in neutral.
Carry out the operations indicated by the instrument: key ON (engine OFF), then the dedicated calibration procedure will be
started → Measurement of Maximum Clutch Travel.
Message "service" will appear on the display; the system in automatic mode will carry out the necessary operations. The procedure
will be interrupted when the engine is switched off.
NOTE Wait 10 seconds prior to the next KEY ON.
When the procedure has been completed, check the control unit memory and verify that no error is found.
Calibration in case of replacement of the gearbox actuator or an electric motor of the gearbox
actuator
Clear the control unit error memory.
Get connected to the vehicle by means of the diagnosis instrument, with the vehicle stationary, engine OFF and gearshift lever
in neutral.
Carry out the operations indicated by the instrument: key ON (engine OFF), then the dedicated calibration procedure will be
started → Transmission Self Adaptation.
Message "service" will appear on the display; the system in automatic mode will carry out the necessary operations. The procedure
will be interrupted when the engine is switched off.
NOTE Wait 10 seconds prior to the next KEY ON.
When the procedure has been completed, check the control unit memory and verify that no error is found.

Calibration in case of replacement of the clutch engaging/release fork

Clear the control unit error memory.
Get connected to the vehicle by means of the diagnosis instrument, with the vehicle stationary, engine OFF and gearshift lever
in neutral.
Carry out the operations indicated by the instrument: key ON (engine ON), then the dedicated calibration procedure will be
started → Adaptation of Touch Point.
Message "service" will appear on the display; the system in automatic mode will carry out the following operations:
- opening the clutch;
th
- engaging the 5
or 6
- the clutch closes three times searching for the point of initial slip (the vehicle will pick up three times);
- putting the lever in neutral;
- closing the clutch.
The procedure is interrupted when the engine is switched off.
NOTE Wait 10 seconds prior to the next KEY ON.
When the procedure has been completed, check the control unit memory and verify that no error is found.
Print 603.93.651
th
speed;
6 S 400 A O.D. TRANSMISSION
Base - March 2006
125