Table of Contents
Advertisement
D
E
4
AILY
URO
Figure 65
α
Complete mounting operation by checking total rolling
torque and the clearance of ring gear and pinion coupling as
described for NDA rear axles.
Position a new seal ring over the gear housing inspection
attachment surface.
Mount the cover (3), insert the fixing screws (2) complete
with tab washers and spring washers.
Tighten the screws (2) with the torque wrench (1) to the
required tightening torque.
NOTE
Do not tighten the screws to a torque greater than
the value indicated since this would impair the
sealing effect of the gasket placed between the
coupling plane and the gear housing inspection
cover.
Mount the differential locking device (if present) and adjust
it as described under the relevant heading.
Mount the drive shafts as described under heading: "525030
Overhauling the Hubs".
Screw on the oil drainage plug and tighten it to the required
torque.
Add lubricating oil in the required quantity and grade through
the hole.
Screw on the oil filler plug and tighten it to the required
torque.
Take the assembly off the stand.
The assembly should be put back on its mounting
NOTE
to prevent the dust guards and/or brake discs from
getting damaged.
Print 603.93.651
18262
81
REAR AXLE 450511
Base - March 2006
Advertisement
Table of Contents
