Fuel Filter “Ufi Filters” - Iveco daily euro 4 Repair Manual

D E 4
AILY URO
542011 Fuel filter "UFIfilters"
Figure 288
1. Fuel filter support- 2. Diesel oil outlet - 3. Diesel oil inlet - 4. Diesel oil filter - 5. Drain screw - 6. Electronic unit - 7. Fastener -
8. 12-way connector - 9. Screw securing Diesel oil filter: H-G-B, water present sensor; - H-C, clogging sensor (if foreseen); -
Fuel filter (4) is made up of a filtering cartridge with water
separator, inside which electronic unit (6) is housed.
Water accumulation capacity is equal to 140 cm
Electronic unit (6) includes water present sensor, (optional)
filter clogging sensor and temperature sensor.
Water present sensor
Water present sensor detects water present in the filter
3
starting from 110 cm volume present. Water present sensor
provides values of:
- low voltage in presence of water;
- high voltage in absence of water.
Characteristics
12V nominal voltage (8V minimum -16V maximum
Absorbed current:
- lower than 15 mA in rest conditions;
- lower than 150 mA in alarm conditions (including load).
Voltage on load:
- in rest conditions: higher than 11.8 V;
- in alarm conditions: lower than 3.9 V.
At key-on operation, the sensor makes a self-test issuing 2.5
second duration sound signal.
Print 603.93.651
D-E, NTC temperature sensor; - F-A, heater.
Normally open contact type.
Operation differential pressure delta p: 0.8
3
.
NTC temperature sensor
Temperature range: -40˚C to +130˚C
Heater
Nominal voltage
Maximum allowed voltage
Nominal power
Tightening torques
9. Screw securing filter
4. Water draining or air bleeding screw
26.114 ohm ± 9.7%
30 ˚C =
5.896 ohm ± 7.3%
0˚C =
2.057 ohm ± 5.6%
+25 ˚C =
596 ohm ± 3.8%
+60 ˚C =
+100 ˚C = 186 ohm ± .2.0%
+110 ˚C = 144 ohm ± 2.4%
147
F1A ENGINE
112723
bar
+0,05
-0,5
12 V
30 V
250 W
1.5 + 0.5 Nm
1.5 + 0.5 Nm
Base - March 2006