Gear Shift Lever Support - Iveco daily euro 4 Repair Manual

D E 4
AILY URO
Figure 5
Disconnect the jointed heads of:
- selection cable (2, max. pull-out load: 250 N - max. pull-in
load: 60 N);
- engagement cable (6, max. pull-out load: 100 N - max.
pull-in load: 80 N) from levers (1 and 5).
Use a suitable screwdriver to open out flexible cable fins (3
and 7) so that the pawls are disengaged from support (4).
Figure 6
Remove nuts (3) securing flange (2) to the cab floor, then take
flexible cable assembly (1) out.
Refitting
Reattachment is carried out by reversing the order
of the detachment operations. Moreover, the
following instructions shall be observed:
- prior to assembling, lubricate the flexible cable
(Bowden) jointed head connection
points with MOLIKOTE 33 LIGHT or
MOLIKOTE G72 grease;
- tighten the nuts and screws to the prescribed
torque;
- adjust the gear control, as described in the
respective chapter.
Print 603.93.651

GEAR SHIFT LEVER SUPPORT

Removal
Figure 7
108852
Proceed as described in figures 5 and 6, by acting from inside
the cab.
Remove fastening screws (2), then take gear shift lever
support (1) off the cab.
Refitting
- prior to assembling, lubricate the flexible cable
(Bowden) jointed head connection points with
MOLIKOTE 33 LIGHT or MOLIKOTE G72
grease;
- tighten the nuts and screws to the prescribed
torque;
- adjust the gear control, as described in the
respective chapter.
108853
11
TRANSMISSION
108854
Base - March 2006