Disassembly Of Gear Housing - Iveco daily euro 4 Repair Manual

D E 4
AILY URO
Figure 32
Mark the position of the caps (1 and 2) and remove them.
Figure 33
Take out the gear housing (1).
Note the assembly position of the adjustment rings (3) and
take them out of the housing together with the spacer rings
(2).
NOTE In the case of reuse, do not swap over the assembly
positions of the external rings (4) of the tapered
roller bearings.
Print 603.93.651

Disassembly of gear housing

Figure 34
44598
Extract the support bearing inner rings (3 and 5) and shoulder
ring (2) from the gear housing and, by means of the puller tool
99348001 (4), extract the counter block (1).
NOTE The thrust ring (2) is only present with rear axles
fitted with differential locking.
Figure 35
NOTE Mark the cover (1) and the gear housing (4).
Unscrew the screws (2), remove the ring bevel gear (3) and
the gear housing (4) cover (1).
Figure 36
44599a
Remove the crown wheel (2) on the cover side with its thrust
washer (3) from the gear housing (1).
Using a generic beater to remove the long pin (4) and the
two short pins (5) from the gearing case (1).
73
REAR AXLE 450511
44600
18222
62099
Base - March 2006