Table of Contents
Advertisement
36
5 S 300 TRANSMISSIONS
Figure 58
Using the bridge 99341003 (1), ties 99341012 (2) and clamp
99341015 (3), extract the reverse gear (5) and the
synchronizer assembly (4).
Figure 59
Remove the roller bearing (1).
Figure 60
Remove the sliding sleeve (2) for engaging reverse - 5
from the hub (1), taking care as the plugs (3) come out with
their relative balls (4) and springs (5), recover them.
Base - March 2006
Figure 61
If the cog-wheel (2) of the 5
75416
damage, take out the retaining ring (3), replace the cog-wheel
(2) and refit the retaining ring (3).
Drive input shaft
Figure 62
If the cog-wheel (2) of the input shaft gear (1) shows any sign
of damage, take out the retaining ring (3), replace the
cog-wheel (2) and refit the retaining ring (3).
51423
Disassembling the transmission shaft
Figure 63
51424
Take out the retaining ring (1) and extract the internal ring (2)
th
of the rear bearing. Turn over the shaft (3) and extract the
gear
internal ring (4) of the front bearing.
Shaft (3) gear (5) removal, if required, shall be performed by
hydraulic press; 50 kN removing load.
D
E
AILY
URO
51425
th
gear (1) shows any sign of
51426
51427
Print 603.93.651
4
5
Advertisement
Table of Contents
