Table of Contents
Advertisement
42
5 S 300 TRANSMISSIONS
Figure 81
Heat the bushing (2) to a temperature no higher than 170°C
and mount it on the main shaft (1).
Mount the sliding sleeve (4) on the hub (3).
Put (3) the springs (7), plugs (5) and balls (6) into the seats in
the hub, settling them under the sliding sleeve (4).
Figure 82
Lubricate the synchronizer ring (4), middle ring (3) and the ring
(2) with TUTELA MR3 grease.
NOTE
Make sure the tongues of the rings (2 - 3) and the
projections of the synchronizer ring (4) are
positioned correctly in their respective seats.
Mount the roller bearing (1).
Base - March 2006
Figure 83
51443
nd
Mount the 2
gear (4).
Heat the spacer (3) to a temperature no higher than 170°C
and mount it on the main shaft (1).
Check the end float of the 2nd gear (4). It should be
0.15 ÷ 0.30 mm.
Heat the bushing (2) to a temperature no higher than 170°C
and mount it on the main shaft (1).
Figure 84
51417
Mount the roller bearing (1) and the 3
synchronizer ring (2) on the 3
D
E
AILY
URO
51445
51446
rd
gear (3). Position the
rd
gear (3).
Print 603.93.651
4
Advertisement
Table of Contents
