Table of Contents
Advertisement
266
F1C ENGINE
Figure 261
Remove the fastening screws (1) and remove tool 99360187
(2).
Figure 262
Position the joint (2) on the stem (3).
Slightly lubricate the seal ring (1) and fit it on the power
steering pump (5).
Fit the power steering pump on the support (4).
Screw down fastening screws (7) complete with spacers (6)
and tighten them to the specified torque.
Figure 263
Lubricate a new seal ring (3) and fit it on the high pressure
pump (4).
Position the joint (2) on the high pressure pump stem (4).
Fit the high pressure pump (4) on the support (1), drive in
the screws (5) complete with spacers (6) and tighten them
to the prescribed torque.
Base - March 2006
Figure 264
88423
Fit heat exchanger (2), complete with a new gasket, onto the
engine base.
Drive in the screws (1) and tighten them to the prescribed
torque.
Figure 265
107740
Connect the low pressure pipes (5) with the new gaskets to
the high pressure pump (2) and tighten the pipe unions (1
and 3) to the prescribed torque.
Drive in the fastening screw (6) of the pipe (5) on the bracket
(4) and tighten it to the prescribed torque.
Figure 266
107741
Lubricate a new seal ring (3), then fit it onto the pipe.
Fit pipe (2) onto heat exchanger (4).
Screw down screws (1 and 5), then tighten them to the
specified torque.
D
E
4
AILY
URO
107711
107710
107742
Print 603.93.651
Advertisement
Table of Contents
