Table of Contents
Advertisement
20
F1A ENGINE
Figure 13
Loosen clamp (9), then take the air conveyor off.
Take air suction sleeve (10) off turboblower (8).
Disconnect the oil pipe (11) from the cylinder head and from
the turbocharger (8).
Loosen the clamp (7) and disconnect the oil pipe (5) from
the crankcase union.
Take out the screws and disconnect the exhaust pipe (4)
from the turbocharger (8).
Take off the nuts (3) and remove the turbocharger (8) with
its gasket from the exhaust manifold.
NOTE
Close
the
appropriately
accidentally getting inside and damaging it.
Disconnect the vacuum pipes from E.G.R. valve (2) and
turboblower (if any) actuator (6).
Base - March 2006
turbocharger
air
outlet/inlet
to
prevent
foreign
Take out the screws and remove the overhead together with
the pins 99360614.
NOTE
The pins 99360614 applied so as not to alter the
timing after removing the timing belt must be
removed from the overhead only if this is to be
removed.
Take off the overhead gasket.
Take out the tappets and carefully put them aside.
Using the bushing 99355041, take out the glow plugs.
Take out the screws fixing the cylinder head and detach this
bodies
from the crankcase.
Remove the cylinder head gasket.
D
E
4
AILY
URO
108561
Print 603.93.651
Advertisement
Table of Contents
