Table of Contents
Advertisement
90
6 S 400 O.D. TRANSMISSION
Figure 132
Fit the transmission shaft coupling (1) onto the output shaft.
If there is any interference, use the tool 99370234 (2) for as-
sembly with the lever 99370317 (3) to lock the coupling.
Figure 133
Mount the washer (3) and screw on the screw (4).
Lock the rotation of the flange (1) with the lever 99370317
(5) and tighten the screw (4) to the required torque.
Mount the tachograph sensor (2) and the reversing light
switch.
Figure 134
Mount the rod (1) preventing engagement of more than one
gear at the same time, in the position marked during disas-
sembly.
Base - March 2006
Figure 135
1
52008
Apply sealant to the thread of the plugs (1 - 3), screw them
into the box, tightening them to the required torque.
Position the driver (4) on the rod (5).
Secure it with the screw (2) after applying LOCTITE 242 onto
its thread.
Figure 136
52009
Fit a new gasket (1) onto the transmission.
1
Apply LOCTITE 510 on the screw threading (2).
Mount the side cover (3) and tighten the fixing screws (2) to
the required torque.
Mount the control box as described under the relevant hea-
ding.
Mount the oil drainage plug, tightening it to the required torque.
Fill the transmission with lubricating oil in the required quantity
and grade.
51925
Mount the oil filler and level indicator cap, tightening it to the
required torque.
D
E
4
AILY
URO
51924
52118
Print 603.93.651
Advertisement
Table of Contents
