Table of Contents
Advertisement
28
AXLE 5818
Figure 11
Fit brake disc (1) and flange (2) onto the wheel hub. Stop
flange (2) rotation by means of a proper lever (3), then
tighten fastening screws (4) to the specified torque.
Using a magnetic dial gauge, check the eccentricity of the
brake disc: it must not exceed 0.125 mm.
Fit the support, together with the brake caliper and braking
gaskets, into place back to the stub axle, by tightening the
fastening screws to the specified torque.
Figure 12
Assemble:
- the wheel on the brake drum;
- the nut protection and screw the fixing nuts.
Tighten the nuts fixing the wheel to the prescribed torque
according to the diagram shown in figure.
Base - March 2006
522820
STUB AXLE REMOVAL AND RE-
FITTING
Perform stub axle removal and refitting as described for axle
5817, without considering the points concerning the
stabiliser bar since the latter is lacking on axle 5818.
109055
D
E
4
AILY
URO
Print 603.93.651
Advertisement
Table of Contents
