Configuring The Modem; Enabling Firewall Settings - Avaya S8500 Installing And Configuring

Chapter 4: Server configuration
2. Type command and click OK to open an MS-DOS command window.
3. Type ping serveripaddress and press Enter, where serveripaddress is the IP
address of the server.
4. Verify that the ping was successful.
5. If DNS is administered, type ping servername and press Enter, where servername is
the host name of the server.
6. Verify that the ping was successful.

Configuring the modem

1. From the Maintenance Web Interface, under Server Configuration click Configure Server.
2. Click Continue until you get to the Specify how you want to use this wizard page.
3. Select Configure individual services and click Continue.
4. On the menu on the left, click Set Modem Interface.
5. Select Change Modem Setting and click Continue.
6. In the Extra Modem Initialization Commands window, type the initialization commands that
are appropriate for your modem and the country of operation. Click Help for help on what
to enter.
For example, to change the country code to Japan, type AT%T19,0,10.
7. Click Change.
The system displays a message that indicates that a modem route was added
successfully.
8. Click Close Window.

Enabling firewall settings

For the server to receive SNMP traps from the UPS and the Avaya Ethernet switch, you must
enable the snmptrap,162/udp port. The default is disabled.
1. From the Maintenance Web Interface, under Security, click Firewall.
2. Scroll down to the snmptrap 162/udp row and select (check) the Input to Server box.
The Output to Server box can be left as is, either checked or clear.
3. Click Submit.
48
Installing and Configuring the Avaya S8500 Server January 2008