Table of Contents
Advertisement
Each hot-swap drive has two LEDs.
Drive LED
Drive status LED (right)
8
Drive activity LED (left)
9
Operator information panel
The operator information panel of the server provides controls and LEDs.
The following illustration shows the operator information panel of the server.
Figure 6. Operator information panel
Table 4. Components on the operator information panel
Callout
Power button with power status
1
System ID button with ID
3
1
Power button with power status
You can press the power button to power on the server when you finish setting up the server. You also can
hold the power button for several seconds to power off the server if you cannot shut down the server from
the operating system. The power status helps you to determine the current power status.
Status
Color
Solid on
Green
Slow blinking
Green
(about one flash
per second)
Fast blinking
Green
(about four flashes
per second)
None
Off
Status
Solid yellow
Blinking yellow (blinking slowly, about
one flash per second)
Blinking yellow (blinking rapidly,
about four flashes per second)
Solid green
Blinking green
Callout
Network activity
2
System error
4
Description
The server is on and running.
The server is off and is ready to be powered on (standby state).
The server is off, but the XClarity Controller is initializing, and the server is
not ready to be powered on.
There is no ac power applied to the server.
Description
The drive has an error.
The drive is being rebuilt.
The RAID controller is locating the
drive.
The drive is powered but not active.
The drive is active.
.
Chapter 2
Server components
19
Advertisement
Table of Contents
