Replacing The Riser Card Assembly - Lenovo ThinkServer RD350G User Manual And Hardware Maintenance Manual

8. Carefully position the new front VGA and USB module on the chassis. Ensure that the VGA and USB
connectors are inserted into the corresponding holes in the front bezel. Align the screw hole in the
new module with the corresponding mounting stud on the chassis. Then, install the screw to secure
the module.
Figure 109. Installing the front VGA and USB module
9. Connect the cable of the front VGA and USB module to the front panel connector 2 on the system
board. See "System board components" on page 33.
10. If you are instructed to return the old front VGA and USB module, follow all packaging instructions and
use any packaging materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement, go to "Completing the parts replacement" on page 142.

Replacing the riser card assembly

your
page and
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Note: Use any documentation that comes with the new riser card assembly and follow those instructions in
addition to the instructions in this topic.
To replace the riser card assembly, do the following:
page
eading and
Chapter 6
133
.
Replacing hardware