Replacing the CD-RW/DVD drive
To remove the CD-RW/DVD drive, complete the following steps.
1. Read the safety information that begins on page v and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Remove the cover (see "Removing the cover" on page 31).
4. Press the release tab 1 down to release the drive 2 ; then, while pressing
5. From the front of the server, pull the drive out of the bay.
6. Remove the retention clip 1 and alignment pins 2 from the drive.
To install a CD-RW/DVD drive, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Make sure that the server and peripheral devices are turned off, and that the
on page 29.
all external cables.
Attention:
In a dc power environment, only trained service personnel other
than Lenovo service technicians are authorized to connect or disconnect power
to the dc power supply. See the documentation that comes with each dc power
supply.
the tab, push the drive toward the front of the server.
on page 29.
power cords and all external cables are disconnected.
Chapter 2. Installing optional devices
73