Fuel Tank Removal - Polaris 2012 RANGER RZR 570 INTL Service Manual

ELECTRONIC FUEL INJECTION
18. Torque PFA nut to specification using the Fuel Pump
Service Too l (PU-5 0326) and a calib rated torq ue
wrench.
Fuel Pump PFA Nut:
70 ± 5 ft. lbs. (95 ± 7 Nm)
19. Verify al ignment of fuel pum p and ta nk orientation
marks.
20. Connect the fuel line to the fuel pump outlet.
IMPORTANT: Be sure to engage the retainer on fuel
line until it snaps into place. Pull on fuel line lightly to
confirm connection.
21. Connect the fuel pump electrical harness.
22. Connect battery.
23. Install the driver and passenger seat.
24. Test the fuel pump by turning on the key and listening
for the pump to activate. Cycle the key several times
to prime the system.
4.24
70 ± 5 ft. lbs.
(95 ± 7 Nm)
= T
Press in retainer
to engage the tabs
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.

Fuel Tank Removal

IMPORTANT: Syphon as muc h fuel from the tank as
possible before at tempting to remo ve it from th e
vehicle.
WARNING
Always wear safety goggles when working with
high pressure or flammable fluids. Failure to do so
could result in serious injury or complications.
1. Remove the dr iver and passenger seats along with
the rear service panel.
2. Disconnect the negative battery cable from the battery
located under the driver's seat.
3. While h olding a sho p towel
connector, disconnect the quick connect fuel line from
the fuel pump. Move the fu el line out of the way for
tank removal.
NOTE: A small amount of fuel may c ome out of the
fuel li ne o r t ank. P roperly drain f uel into a suitable
container.
over th e fu el lin e