Bearing Carrier Installation - Polaris 2012 RANGER RZR 570 INTL Service Manual

FINAL DRIVE
Bearing Installation
5. Thoroughly clean th e fro nt bea ring car rier ho using
and the outer race on the new bearing. Be sure that
all oil residue has been removed from each surface.
6. Support the bottom of the bearing carrier housing.
Use an arbor and press only on the outer race,
otherwise bearing damage may occur.
7. Apply Loctite® 60 3™ retaining comp ound to the
outer circumference of th e ne w bearing r ace and
carefully pr ess the ne w b earing into the b earing
carrier housing.
Apply
Loctite® 603™
Snap Ring
NOTE: Use ca re to not allow any of t he L octite®
compound to get in the bearing.
8. Wipe the housing clean of any excess compound and
install the snap ring.
7.4
CAUTION
Bearing
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.

Bearing Carrier Installation

1. Install drive shaft axle through th e b ackside o f the
bearing carrier.
2. Install the upper and lower ball joint ends into the fr ont
bearing carrier.
3. Install pinch bolts and torque to specification.
23 ft. lbs.
(31 Nm)
Ball Joint Pinch Bolts:
23 ft. lbs. (31 Nm)
4. Apply grease to drive shaft axle splines.
= T