Drive Shaft Installation; Wheel Hub - Polaris 2012 RANGER RZR 570 INTL Service Manual

FINAL DRIVE

Drive Shaft Installation

1. Install new spring ring on drive shaft. Apply anti-seize
compound to splines.
2. Align splin es o f drive sha ft with rear g earcase a nd
reinstall the drive shaft. Use a rubber mallet to tap on
the outboard end of the drive shaft if necessary.
NOTE: Take c are when in stalling the d rive sh aft to
prevent damaging the seal.
3. Slide the rear drive shaft into the rear bearing carrier.
7.38
NEW
Spring Ring
Apply
Anti-Seize
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
4. Lift bea ring carrier into place an d install th e bolt
attaching the bea ring carr ier to th e up per A-a rm.
Torque fastener to specification.
Upper Rear Bearing Carrier Bolt:
40 ft. lbs. (54 Nm)
5. Apply grease to drive shaft axle splines.
6. Install rear wheel hub assembly, cone washers, and
hand tighten the castle nut. Install washers with
domed side out.
Cone Washers
Wheel
Hub
= T
Out