Stator Removal - Polaris 2012 RANGER RZR 570 INTL Service Manual

ENGINE / COOLING SYSTEM
10. Torque new flywheel nut (B) to specification.
C
B
Flywheel Retaining Nut:
133 ft. lbs. (180 Nm)
11. Install starter idler gear and shaft (C).
3.72
= T
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.

Stator Removal

NOTE: Test stator wire continuity before removing it
from the housing.
Remove the stator cover as o utlined in the "Water
1.
Pump Me chanical Seal / Oil Se al Re placement"
procedure" in this chapter.
The flywheel contains powerful magnets.
Use caution when removing the stator cover.
DO NOT place fingers between cover and
crankcase at any time during the removal
process or injury could result.
2. Remove and discard the stator cover gasket.
CAUTION
Be sure engine coolant does not contaminate
the engine oil during stator cover service.
3. Remove the 3 bolts (C) that secure the stator to the
stator cover.
4. Remove the 2 bolts that secure the stator wire routing
bracket (D) to the stator cover.
5. Remove the stator (E) from the stator cover.
Apply Crankcase
Sealant
CAUTION
C
D
E
6 ft. lbs.
(8 Nm)
9 ft. lbs.
Apply Loctite
(12 Nm)
Apply Loctite