Bearing Carrier Bushing Replacement - Polaris 2012 RANGER RZR 570 INTL Service Manual

FINAL DRIVE
Bearing Installation
1. Thoroughly cle an the rear be aring car rier ho using
and the outer race on the new bearing. Be sure that
all oil residue has been removed from each surface.
2. Support the bottom of the bearing carrier housing.
Use an arbor and press only on the outer race,
otherwise bearing damage may occur.
3. Apply Loctite 603
™
®
circumference of the new bearing race and carefully
press th e ne w be aring into
housing.
Apply
Loctite® 603™
Snap Ring
NOTE: Use ca re to no t allow any of the L octite
compound to get in the bearing.
4. Wipe the housing clean of any excess compound and
install the snap ring.
7.28
CAUTION
retaining compound to the outer
the bearing ca rrier
Bearing
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.

Bearing Carrier Bushing Replacement

Check be aring carrier bu shings and piv ot tu bes for
excessive wear or d amage. If r eplacement is r equired,
slide p ivot tube s out a nd re move bu shings with a d rift
punch. Install new bushings by pr essing th em into th e
bearing carrier.
Bearing
Carrier
®
Pivot Tube
Control Arm
Bushing