Polaris 2012 RANGER RZR 570 INTL Service Manual page 288

TRANSMISSION
12. Loosen the ( 3) clam ps secur ing the intake ba ffle
assembly to th e a ir b ox lid, in ner clutch cover an d
engine crankcase vent. Remove the air intake baffle
/ intake hoses / en gine cr ankcase ven t tube
assembly as shown below.
Spring Style
Clamp
13. Remove the o uter clutch cover , dri ve belt, dri ve
clutch, driven clut ch and inner c lutch c over (see
Chapter 6). Make note of hose and wire routings for
reassembly.
IMPORTANT: Be sure to use the correct Drive Clutch
Puller ( PN PA-4 8595) to p
crankshaft.
14. Loosen the hose clamp that secures the air box to the
throttle body. Cut the t ie strap that secures the wire
harness to the right-hand side of the air box. Remove
the air box assembly.
8.6
an
revent damage to
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
15. Place a shop to beneath the fuel line quick connector
to catch a ny excess fuel. Disconnect the fuel line from
the fuel rail by pressing in on the quick connector tabs.
Move fue l line to th e left-h and sid e of th e en gine
compartment. Make note of line r
installation.
16. Disconnect the IAC valve (A), TPS (B), T-MAP sensor
(C), harness leads from the throttle body.
A
B
17. Remove throttle body from the engine and wrap it with
a clean shop towel. Place throttle body on the LH side
frame rail area.
IMPORTANT: Be sure dirt and debris do not enter the
engine, air box or throttle bod y. Use clea n sh op
towels to plug engine and air box intake holes.
outing for
C