Propshaft Service; Removal / Installation - Polaris 2012 RANGER RZR 570 INTL Service Manual

FINAL DRIVE

PROPSHAFT SERVICE

Removal / Installation

1. Remove both seats and the engine service panel as
outlined in Chapter 5.
2. Disconnect the negative (-) battery cable.
3. Raise and support vehicle and remove the left-hand
rear wheel.
Serious injury may result if machine tips or falls.
Be sure machine is secure before beginning this
service procedure. Wear eye protection when
removing bearings and seals.
4. From th e right-hand front wheel well, locate the
propshaft roll pin. Use the Roll Pin Removal Tool (PN
2872608) to r emove the ro ll pin fro m th e fro nt
gearcase.
Roll Pin Removal Tool (PN 2872608)
5. Remove the o uter clutch cover, drive belt and drive
clutch as outlined in Chapter 6.
7.12
CAUTION
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
6. Disconnect the ha rness con nector at the bra ke
switch. Remove the (2) screws securing the brake line
junction block and move the jun ction block towards
the left-hand frame rail.
7. Remove the g ear sele ctor ca p a nd remove the
retaining screw and handle.
8. Remove the Torx screws retaining the center console
to access the propshaft.
Cap
Torx Screws
Torx Screws
Screw
Handle
Torx Screws